LOG IN TO WEBIKE

Easily Using

Or Using E mail

SIGN UP TO WEBIKE

Easily Using

Or Using E mail
arrow-image

SUZUKI

20 Customer Reviews

GO TO REVIEWS

reviews

Rear brake operation of klx 125 is now easier. Because Lever is set horizontally with Rubber cover attached, we used this Parts to lower Lever effectively it became easier to use


- By Japan User(translated)

Ratings

I chose by design and price.
It is a place to install, but there is no particular problem in mounting.
However, while the STD Disc covers all the mounting parts of the Wheel, this disc has a portion that is exposed as Design.
Where aging deteriorates, Wheel's concern about corrosion.

- By Japan User(translated)

Ratings

When removing the Footpeg Rubber of KLX 125, the footpeg position will go down, so you need to lower Brake pedal by that much. But as OEM's Crevice remains, the adjustment range is small, so this Zeta made Crevice will be on its way.
The total length is shorter than OEM, so it will be possible to lower the Pedal position than OEM.
I think it would be better to remove Footpeg Rubber and wear off-road boots, or exchange it if it converts to Rear Sets.

- By Japan User(translated)

Ratings

Mounting to WR 250 R. I have exchanged all Motorcycle owned by my favorite with high texture.

Since WR 250 has resin cover on MASTER, it can not be installed unless it is removed. Covering with Cover can easily remove it, but be careful not to pinch the Rubber packing and install it.

Although it is an appropriate Gold amount, it is a prominent part and the satisfaction level is ☆ 5

- By Japan User(translated)

Ratings

I also installed it also on the YFZ 450 because the Dress-up effect is also high.

Especially installation is not difficult, but spilling Brake fluid must be removed securely paint such as MASTER will be ruffled.

Quantity : Pair (for Left and Right) Hitoshi etc. If you do not tighten it, it leaks out when it falls, so it is caution.

- By Japan User(translated)

Ratings

It installed in RMX 250. BoltQuantity : It is easy to replace because it is only 2 pc, but do not spill Fluid and OEM Bolt is easy to lick so be careful when removing the OEM.

Since DRC and Reserver CoverBolt are sold cheaply, they may be exchanged together.

The appearance is the best. The price is reasonable, but from the conspicuous Impact and texture it seems that it is not so high.

I will exchange other owned motorcycle.

Even if you are running, you are surrounded by Handlebar, so your satisfaction level is UP.

- By Japan User(translated)

Ratings

It is conspicuous not to compare with NORMAL's Gray alumite. I do not like Honda Red in the car body so I like it outstandingly.
The exchange is very easy, Quantity : Loosen 2 pc Screw and NORMAL lid and Material : Remove the middle plate of Plastic, just attach ZETA so that Garbage will not enter and tighten Screw.
Screw was also rusted at the same time, so I bought it at Home center and exchanged it, so he is Mold Ka.
... If a bit cheaper ...

- By Japan User(translated)

Ratings

I bought it because I like ZETA.
Since installation is removed only by removing NORMAL, I think that anyone can do it.
I'm aligned with Blue, but Red is also good.
It looks just like it looks, but the price is also cheap, and a slight change in appearance is also good.

- By Japan User(translated)

Ratings